AQARA - G2H Camera Hub - CH-H01

Go to Aqara Home app, click "..." in the upper right corner > More settings > Camera settings > Video settings > Image inversion, and fix the video image by adjusting it from top down or from left to right.

The stand base of Aqara Camera Hub G2H contains two strong magnets, which support magnetic attraction to refrigerators, iron doors and other objects, and can also be attached to non-magnetic attraction objects to using 3M tape and iron pieces in the accessories. Please use them to install the bracket.

After adding the device to the Apple Home app, you must install a HomePod, Apple TV (tvOS 11.0 or later) or iPad (iOS 12.0 or later) that has been set as a home center to achieve control from a distance. For specific operations, please refer to the Apple Home app instructions.

There is no limit to the number of clients, but it is recommended that no more than 4 clients are watching at the same time, because the more clients the hub is connected with, the more resources the processor consumes and too real-time image client connections may freeze or delay the display.

Correlation event means the Aqara Camera Hub G2H can be correlated with devices in the same house, such as when the door and window sensor is triggered, after detecting human motion, the hub can help locate the time position of the event in the recording area. The maximum number of correlation events is 100. Set a correlation event: click on the application > "Correlation Events" in the lower right corner > select the device to trigger the correlation event > select the color > save.

Yes, but you cannot view the video from the MicroSD card remotely through the app without a network connection.

1. Some imitation small capacity memory cards claim to be sold as large capacity cards.

2. After some devices have been tested, MicroSD cards may be maliciously partitioned and devices can only read the partition partially.

3. Because the manufacturer's capacity formula is different (the actual measurement unit of normal capacity is 1024KB=1MB and the manufacturer's measurement unit is 1000KB=1MB), the actual capacity will be slightly lower than indicated on the card label.

The Aqara Camera Hub G2H can record high definition videos by default. An 8GB memory card can record videos for 18 hours. 16GB memory card can record videos for 36 hours; A 32GB memory card can record videos for about 3 days.

The Aqara Camera Hub G2H supports MicroSD cards in FAT32 format, with Class 4 or better read and write speed. However, it is recommended that you choose a MicroSD card with a Class 10 or higher read and write speed and that supports the maximum capacity of 32 GB.

The hub of the Aqara Camera Hub G2H can be connected via the ZigBee 3.0 protocol and can directly support up to 32 Aqara devices.

Aqara Camera Hub G2H hub can be connected with Aqara's other smart sensors and controllers, such as door and window sensor, motion sensor, smart plug, wireless switch and others devices. Thanks to the hub function, you can control these smart devices with the Aqara Home app. The hub is the data interaction and control center for your entire smart home network.

1. The distance between the device and the wireless router is too far or there are many obstacles in the middle. When the Wi-Fi signal is weak, the network connection may fail. Please use a Wi-Fi signal booster to relay the signal or move the router near a place where the device can receive the Wi-Fi signal well.

2. When incorrect Wi-Fi information is entered, the network connection cannot be established. Please enter the correct information and try again.

The Aqara Camera Hub G2H supports Wi-Fi with IEEE802.11b/g/n 2.4 GHz protocol and does not support 5 GHz Wi-Fi.

You can scan the QR code to connect the Aqara Camera Hub G2H to the network. After the device is turned on, open the Aqara Home app and connect the device to 2.4GHz Wi-Fi according to the voice prompt. The QR code is then generated and you can scan the QR code through the lens of the G2H camera for network connection.