AQARA - ZigBee Intelligent Magic Cube Controller - MFKZQ01LM

You can rename the controllers to distinguish them. Once the Cube controller is connected to the Hub, you can name it whatever you want or you can long press the associated controller icon in the app to rename it.

Please make sure the distance between the Hub and the Cube is within 10 meters. If this situation occurs, please move the Cube closer to the Hub.

1. The Cube still works properly. Depending on the actions defined in the application, when different actions are taken, different results will be executed. For example, before the network disconnects, you can configure in the APP, Flip 180° of the Cube to activate or deactivate the Smart Plug (please note that the Cube and the Smart Plug are connected to the same Hub). Once disconnected, he can still control this action properly.

2. If the network is disconnected, you cannot use the APP to control, but the local automation still works properly.

The maximum indoor response distance between the Cube and the Hub is approximately 10 meters (including barriers, such as walls). The maximum outdoor response distance is 65 meters.

Please place the Cube on the flat surface to use. If you use it on a soft surface, like a couch or a pillow, some actions may not work properly.

After the Cube controller is successfully added, you can check out the actions tutorial video. You can also check "More" in the upper right corner of the Cube page to watch the action demo.

No, it cannot connect directly to your smartphone. Please connect the Hub to your smartphone first, then connect the Cube to the Hub.

The Cube uses a gyroscopic sensor and you can use the designated action in any direction.

1. The Cube is too far from the hub. Please try to move it closer to the hub;

2. The wireless network disconnects or other reasons that cause the hub to disconnect;

3. The battery may be exhausted. Please replace the battery and try again.

1. Open the bottom cover by inserting the metal strip into the slot

2. Move the Cube close to the Hub, add the sub-device to the Hub via APP. The Hub issues a “Ready to connect” voice prompt.

3. Long press the reset button in the bottom cover to connect it.

The Cube can control all smart devices that can perform actions in the app. For example, shake to control the night light on the hub; Flip 90° to enable or disable the smart plug; Flip 180° to control the wall switch.