PHILIO - 4 in 1 detector (Door/Window, Motion, brightness, temp)
The Philio Multi Sensor is a Z-Wave door/ window sensor, motion sensor, luminescence sensor and temperature sensor in one package.
Security guarantees
Shipping Policy
The Philio Multi Sensor is a Z-Wave door/ window sensor, motion sensor, luminescence sensor and temperature sensor in one package. Thanks to this the PST02-1A can be uses as a security device or home automation device, e.g. to send an alarm when a motion is detected, turn the light on/ off automatically at night or to adjust the heater.
The product consists of two elements - the detector and the magnet. The magnet is mounted on the moving part of the window or of the door. The other part is placed on the frame.
When included securely the device is able to accept secure commands and to send secure commands to other devices. The commands and the receiver of the commands sent out on single click and on double click of the rocker can be defined in configuration parameters and association groups.
TECHNICAL SPECIFICATIONS :
- Power by: CR123A lithium battery
- Signal (Frequency): 868.40 MHz
- Range: Minimum 40 meters indoor, 100 meters outdoor line of sight
- Operating Temperature: -10oC ~ 40oC
- For indoor use only
- RF Maximum Power: +5dBm
Data sheet
- Type
- Sensor
- Functions
- Luminosity
Motion
Open / Close
Temperature - Technology
- Z-Wave Plus
- Power Supply
- Battery
- Compatibility
- Eedomus
Fibaro HC3
Fibaro HC3 Lite
Homey
Jeedom
Anonymous customer published the 19/04/2021 following an order made on 23/02/2021
Inclusion OK avec eedomus, Les 4 fonctionnalités sont détectées et le tout fonctionne bien.
- Appuyez sur le contact anti-sabotage 4 fois en moins de 1,5 secondes, et lors du quatrième appui, maintenez le contact enfoncé jusqu'à ce que la LED s'allume.
- Après 3 secondes la LED s'éteint, attendez 2 secondes pour relâcher le contact anti-sabotage. Si la réinitialisation a réussi, la LED s'allume 1 seconde. Sinon la LED clignote une fois.
- Le Node ID est exclu et tous les paramètres sont réinitialisés par défaut.
- Mettez votre contrôleur Z-Wave en mode exclusion.
- Appuyez sur le contact anti-sabotage 3 fois en moins de 1,5 secondes. Le node ID a été correctement exclu.
- Mettez votre contrôleur Z-Wave en mode inclusion.
- Appuyez sur le contact anti-sabotage 3 fois en moins de 1,5 secondes.
- Après une inclusion réussie, le détecteur se réveille pour recevoir les commandes de configurations envoyées par le contrôleur Z-Wave dans les 20 secondes.