EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
search
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons
  • EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons

EUTONOMY - Adapter DIN for Fibaro Double Switch FGS-223 with buttons



EUT_S223
€46.80 Tax included

The euFIX S223 Adapter is used to install the Fibaro® Double Switch FGS-223 module on DIN TH35 type rail in the electrical switchboard.

Quantity

 

Security guarantees

 

Shipping Policy

The euFIX S223 Adapter is used to install the Fibaro® Double Switch FGS-223 module on DIN TH35 type rail in the electrical switchboard.

The euFIX S223 Adapter consists of the case and the base board, where the FGS-223 module is mounted. The dimensions of the case are appropriate for a standard DIN TH35 type rail.

The base board contains a set of screw terminals, where all the wires (power supply, input and output signals, control push- buttons) can be safely connected.

The front panel of the case contains two diagnostics micro-push-buttons S1 & S2, which can be used to control the module, to register the module within the Z-Wave system or to remove it from the system without opening the adapter's case. 

FEATURES :

  • DIN adapter for Fibaro Double Switch FGS-223 with push-buttons
  • Used to install the Double Switch FGS-223 module on DIN TH35/TS35 type rail in the electrical switchboard
  • Free location on the label to locate the controlled line
  • Micro-push-buttons S1 & S2 used for control, inclusion or exclusion of the module within the Z-Wave system

TECHNICAL SPECIFICATIONS :

  • Supply voltage: 230 V AC +/-10%, 50–60Hz 
  • Load power: max 6,5 A per channel, 10 A in total
  • Dimensions: 34.8 x 87.3 x 64.7 mm
  • Width in TE units: 2 TE modules
  • Conductor wires cross section: max. 2.5 mm2 
  • Maximum length of wires connected to Sx, S1, S2 inputs: 20m
  • Operating temperature: 0 °C to +50 °C
  • Relative humidity: ≤90 %, no condensation
  • Directives:
    • LVD 2014/35/EC
    • RoHS 2011/65/EU 
EUT_S223

Data sheet

Type
Accessory
Accessory Type
Adapter

You might also like