How to Reset Aeotec Door/Window Sensor 7 Pro
This device also allows being reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
To manually factory reset:
1. Remove the cover of Door / Window Sensor 7
2. Press and hold tamper switch for 5 seconds until the red LED blinks.
3. Release the tamper switch
4. Immediately press and hold the tamper switch again, the LED will flash red 5 times while holding.
5. A green LED will confirm reset, which you may release the tamper switch.
Related Products
Does this answer your question?
Sorry about that
How can we improve it?
Thanks