H-TRONIC - Start Current Limiter ESB200

Optimal protection for problem loads. To limit inrush currents in problem loads, e.g. Energy saving lamps and parallel compensated fluorescent lamps. Problem loads such as electronic ballasts, energy saving lamps, incandescent lamps, LED power supplies and switching power supplies have a very high current consumption at the switching-on moment with the multiple of the nominal current and can thus destroy switching relays.With this accessory, the high current which can occur when electronic devices are switched on is limited to a harmless value.

The inrush current for incandescent lamps can also be limited so that they reach a higher service life. In addition, a protection fuse is integrated. The inrush current limiter can be directly connected to the load circuit for loads up to 200 VA.The compact device can be installed in switch or distribution boxes or e.g. Lamp housings can be installed very easily. The device is simply installed in series with the load.

Note: The max. connection power of 200 W may be not exceeded!

FEATURES : 

• Start current limiter
• Installation in series with the load
• Built-in fuse
• Compact dimensions

TECHNICAL SPECIFICATIONS :

• Power supply: 230V / 50Hz
• Peak inrush current: 90A / 1 mS
• Ambient temperature: 5 – 35 degrees
• Load: max. 200VA
• Connection: two flexible connection cables with approx. 100 mm length
• Dimensions (L x W x H): 28 x 23 x 10 mm
• Weight: 10 g