How to add the Fibaro Flood Sensor to the Z-Wave network?
1. Open the lid.
2. Place the flood sensor in direct range of your Z-Wave controller.
3. Put your Z-Wave controller in include mode (see controller manual).
4. Quickly press the TMP button three times.
5. Wait for the inclusion process to complete.
6. Successful inclusion will be confirmed by the message from the Z-Wave controller.
If the sensor is not included, reset it and repeat the inclusion procedure.
Inclusion in security mode must be carried out up to 2 meters from the controller.
Related Products
Does this answer your question?
Sorry about that
How can we improve it?
Thanks