FIBARO ROLLER SHUTTER 4 is a device designed to control roller blinds, awnings, venetian blinds, curtains and pergolas. FIBARO ROLLER SHUTTER 4 allows precise positioning of roller blinds or venetian blind slats. The device is equipped with energy monitoring. It allows to control connected devices either via the Z-Wave network or via a switch connected directly to it.
New devices design
FIBARO focused on easy installation and intuitive first run. There are more inputs for N and L wires, so that allows opt-out from using splicing connectors.
Smaller device
Device's shape and dimension enable easy and fast installation in flush-mounted boxes. Button and the diode are easily accesible.
Equipped with plug connectors
Enable even faster assembly - no need to use screw driver.
3 Extra connecting cables included in the box
Additional wires to connect the button are included.
Inbuilt Bridge
Easy bridging option for live and neutral. There is no need to use wago connectors for connecting wires. You save the space in the box and shorten installation time thanks to push-in wires connector.
Comparison FGR-223 vs FGR-224
Features of Fibaro Roller Shutter 4
Compatible with any Z-Wave or Z-Wave+ Controller
One of the smallest shutter controller available
Equipped with Z-Wave 800 chip to provide better range
Supports Z-Wave network Security Modes: S0 with AES-128 encryption and S2 Authenticated with PRNG-based encryption
Can be used with roller blinds, venetian blinds, pergolas, curtains, awnings, blind motors with electronic or mechanical limit switches
Active power and energy metering functionality
Works as a Z-Wave signal repeater (all non-battery operated devices within the network will act as repeaters to increase reliability of the network
Works with various types of switches – momentary, toggle and dedicated roller blind switches
Easy and quick too install thanks to push-in wires connector and inbuilt bridge
To be installed in wall switch boxes
Technical specifications of FIBARO FGR-224
Power supply: 100-240V~50/60Hz
Rated load current: 2A for motors with compensated power factor (inductive loads)
Supported motor type: single-phase AC motors
Required limit switches: electronic or mechanic
Operating temperature: 0°C - 35°C
For installation in boxes: Ø = 50mm, depth ≥ 60mm
Radio protocol: Z-Wave (800 series chip)
Radio signal power: up to 5dBm
Radio frequency band: 868.4 MHz
Range: up to 100m outdoors, up to 30m indoors (depending on the terrain and building structure)
Dimensions (L x W x H) 46mm x 36mm x 19,9mm
Compliance with EU directives: RoHS 2011/65/EU, RED 2014/53/EU