HEATIT CONTROLS - Z-TEMP2 Z-Wave+ thermostat for waterbased heating
Heatit Z-Temp2 is a temperature sensor designed for use with waterbased heating systems.
Heatit Z-Temp2 is a temperature sensor designed for use with waterbased heating systems. Using it in combination with the Heatit Z-Water regulator allows for an advanced waterbased heating solution that can be managed from a Z-Wave gateway. This is a “wire-free” solution, saving both time and money. All communication between the Heatit Z-Temp2 and the controlled device is 100% wireless. Heatit Z-Temp2 has SmartStart. This feature allows the user to include all devices with SmartStart by scanning the QR codes on the devices. On startup all the devices will automatically be included in the gateway (requires SmartStart compatibility). This saves the installer a lot of work.
Heatit Z-Temp could also be used in situations where a traditional electrical thermostat is not suited. The thermostat may be combined with the Heatit Z-Relay as the actuator installed in a remote location. The Heatit Z-Temp2 is an excellent choice when restoring or remodeling existing buildings, as it is easy to install without any need for wiring.
- Z-Wave thermostat for controlling external relay
- Internal room sensor
- Humidity sensor
- Proximity sensor to turn on the display
- Automatic brightness control
- Firmware updates (OTA)
- Weekly program/setback via gateway
- Lock mode/child lock
- Supports encryption modes S0, S2 Authenticated Class, S2 Unauthenticated Class
TECHNICAL SPECIFICATIONS :
- Protocol: Z-Wave Plus V2, 868,4MHz
- Chip: Z-Wave 700 chip
- Rated voltage: 3 x AA batteries (1,5V)
- Ambient temperature: 0°C til 60°C
- Humidity: Max. 85% RH
- Range RF: Min. 40 meters
- Hysteresis: 0,3°C to 3,0°C (default 0,5°C)
- IP Code: IP 21
- Dimensions: 85 x 85 x 25 mm
- Approvals: Z-Wave Plus, CE RoHS, 2011/65/EU
- Z-Wave Plus V2
- Power Supply
- Thermostat Type
- Programmable thermostat
Fibaro HC3 Lite
- Z-Wave specificity
- Security S2
Pressing and holding the bind button for 20 seconds will cause the thermostat to perform a full factory reset. rES will be displayed.
Please refer to your main controller/gateway manual for how to enter exclusion mode. The device can only be deleted from the network if the main controller is in exclusion mode.
When the main controller/gateway is configured in exclusion mode, press the link button on the thermostat 3 times in a rapid sequence (less than 1.5 seconds).
Please refer to your main controller/gateway manual for how to enter inclusion mode. The device can only be added to the network if the main controller is in inclusion mode.
When the main controller/gateway is configured in inclusion mode, press the link button on the thermostat 3 times in a quick sequence (less than 1.5 seconds).
You might also like
8 other products in the same category:
- On sale!