

Monitor your door, window, garage door or gate with the Tilt/Shock Sensor ZSE43 from Zooz !
Security guarantees
Shipping Policy
ZSE43 sensor can monitor door, window, garage door or gate. Get reliable open/close reports for garage doors and gates. Monitor window or door glass from your Z-Wave hub to boost security.
Doors, windows, and garage gates are the most vulnerable entry points to your home. This sensor was designed to offer additional protection to all of them with fast wireless status reports.
Choose to use it as just a tilt sensor or a simple vibration detector and if needed, get both types of reports for the doors and windows you want to monitor. The tilt sensor can be programmed to send a notification if your garage is open. With the shock sensor functionality, you’ll be able to tell if the glass on your basement window has been broken or tampered with.
As always, a Z-Wave hub is required to use our smart security products. Please check the compatibility list below before purchasing the sensor to make sure your system supports it.
Enjoy hardware and software enhancements from the latest tech with this extra small unassuming smart sensor.
It’s just under 5 cm tall and only 0.8 cm thick, making it over 50% smaller than the other popular Z-Wave tilt sensors out there. Despite its size, the device has up to 50% more range and sends quicker reports thanks to the 700 series Z-Wave chip.
It runs on a single CR2032 coin battery that’s easy and cheap to get once it’s time to replace it. And with a dedicated weatherproof case (sold separately), you can safely use this sensor outdoors without any extra protection.
Use this sensor with our MultiRelay and create a fully automated garage door system. The sensor will keep you in the know by reporting open / close status of the gate while the relay allows you to control the opener remotely.
Connect up to 3 openers to the MultiRelay and activate them individually – that’s 3 gates made smarter with a single device. Put the Tilt/Shock sensor on each door to complete the set-up.
FEATURES :
TECHNICAL DATAS :
Data sheet
Robert P. published the 05/04/2023 following an order made on 28/03/2023
Acheté le produit pour remplacer un inclinomètre Vision ZG8101 qui ne se trouve plus. Le capteur est très petit et ressemble à des capteurs d'ouverture Aqara Zigbee. Insertion dans Jeedom laborieuse qui a nécessité une mise à jour du plugin Open Zwave et un changement de pile (1 étoile en moins) Fonctionne bien pour le moment.
Frederic D. published the 16/07/2022 following an order made on 20/04/2022
L'inclinaison donnée n'est pas sûre, une fois sur deux c'est incorrect. Pas fiable
Gerard G. published the 03/07/2022 following an order made on 26/06/2022
Configuration sans problème sur Home Assistant
SAMUEL G. published the 19/06/2022 following an order made on 14/06/2022
Conforme sauf inclinaison avec eedomus fonctionne pas à moins que j’ai pas trouver dans les paramètres
Paul S. published the 25/05/2022 following an order made on 09/04/2022
Pour le moment connection Jeedom OK mais sans être reconnu. produit qualitatif visuellement.
You might also like