ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41
search
  • ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41
  • ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41
  • ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41
  • ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41
  • ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41
  • ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41

ZOOZ - Z-Wave Plus 700 Series XS Open/Close Sensor ZSE41



ZSE41
€27.95 Tax included

Monitor your door or window with the Open/Close Sensor ZSE41 from Zooz !

Quantity

 

Security guarantees

 

Shipping Policy

  

ZSE41 sensor can monitor a door or a window. Get a notification to your phone from your Z-Wave hub when your front or back door is open,  or turn off the AC in your smart thermostat and get a text from the hub if the windows are left open.

Simplified Security

Start building your own private security system with Z-Wave door / window sensors. Monitor the entry points yourself and decide when to take action.

Just mount the sensor on the front door, add it to your hub, and set up notifications or security sirens to go off whenever the system is armed. With a Z-Wave set-up, you’ll have more control and more flexibility when it comes to managing security equipment.

Smart Set-Up

This sensor was designed to make DIY security more approachable. From hardware to software, everything in this device caters to a safer and friendlier smart home.

It’s only 0.8 cm thick and under 5 cm tall, with a sleek form factor to help you mount the sensor anywhere. You can install it outdoors with the weatherproof case accessory to monitor your gates or even a mailbox! The adhesive mounting tape is included and you’ll also find the screws for an outdoor installation of the magnet if needed, right in the box.

You can place the magnet on either side of the sensor to accommodate any unique detection scenarios. The device runs on a popular CR2032 coin battery, making it easy and affordable to maintain.

FEATURES :

  • Quick and reliable open/close alerts sent to your Z-Wave hub
  • New 700 series chip for faster communication and more battery life than ever
  • Extra small for discreet mounting
  • Waterproof case available for outdoor installs (sold separately)
  • Powered by a single coin battery
  • The latest S2 security and SmartStart for secure set-up
  • Supports OTA firmware updates

TECHNICAL DATAS :

  • Power supply: 1 CR2032A battery (included in the box)
  • Z-Wave Signal Frequency: 868.42 MHz
  • Range: Up to 100m line of sight
  • Magnet to sensor max gap: 0.6 cm
  • Installation and Use: Indoor or outdoor with waterproof case (sold separately)
  • Operating Temperature: 0-40° C
  • Dimensions: 4,8 x 0,8 x 2,5 cm (magnet: 3,2 x 0.8 x 0.8 cm)

ZSE41

Data sheet

Type
Sensor
Functions
Open / Close
Technology
Z-Wave Plus V2
Power Supply
Battery
Compatibility
Eedomus
Fibaro HC3
Fibaro HC3 Lite
Home Assistant
Jeedom
Z-Wave specificity
Security S2
SmartStart

Download

Notice ZSE41

Notice d'utilisation du capteur Zooz ZSE41

Download (641.29KB)
View the trust certificate
  • For further information on the nature of the review controls, as well as the possibility of contacting the author of the review please consult our Transparency Charter.
  • No inducements have been provided for these reviews
  • Reviews are published and kept for a period of five years
  • Reviews can not be modified: If a customer wishes to modify their review then they can do so by contacting Verified Reviews directly to remove the existing review and publish an amended one
  • The reasons for deletion of reviews are available here.

3.5 /5

Based on 8 customer reviews

  • 1
    1
  • 2
    2
  • 3
    1
  • 4
    0
  • 5
    4
Sort reviews by :

Imidio S. published the 27/03/2023 following an order made on 18/03/2023

5/5

conforme

Did you find this helpful? Yes 0 No 0

Christian B. published the 21/02/2023 following an order made on 07/02/2023

5/5

bien

Did you find this helpful? Yes 0 No 1

Frederic C. published the 06/02/2023 following an order made on 30/01/2023

1/5

J'ai dernièrement acheté 2 capteur ZOOZ d'ouverture porte/fenêtre Z-Wave+ 700 ZSE41. Mon retour est très positif concernant la mini taille du capteur et le fait qu'enfin un constructeur ait pensé à un boitier étanche (mais la visserie livrée avec est de piètre qualité). Par contre, pour les 2 capteurs, la portée est totalement insuffisante, dès lors que ce genre de capteur étanche est destiné à être positionné à l'extérieur de la maison (plus de 20 mètres de la box eedomus ou d'un répéteur Zwave). La réception radio, et donc des informations "ouvert/fermé", devient très aléatoire et donc totalement inefficace pour recevoir une information fiable. Et ce, malgré une multitude de tests de maillage et d'optimisation Zwave en tous genres. La miniaturisation de l'antenne intégrée au PCB du capteur ne doit vraiment pas aider. Les remontées de pourcentage restant de la batterie sont folkloriques. On passe de 100% à 25% en 5 minutes. Puis on repasse à 30% ?! Le changement par 1 pile neuve CR 2032 (Energizer Ultimate au Lithium) n'affiche même pas 100% ! Je suis donc au final très déçu par ce capteur et je ne le destinerai surtout pas à la détection d'ouverture de mon portail. Dommage, car l'idée était bonne.

Did you find this helpful? Yes 1 No 0

Alzy -. published the 02/02/2023 following an order made on 23/01/2023

2/5

A cessé de fonctionner après 3 jours. Le capteur ne réagit plus aux ouvertures. Ne fonctionne toujours pas correctement après changement de pile, réinitialisation d'usine, nouvelle association). J'attends le retour du SAV.

Did you find this helpful? Yes 1 No 0

Denis B. published the 31/01/2023 following an order made on 23/01/2023

2/5

Bof, très faible portée en extérieur même avec des modules répéteurs. Non reconnu correctement par Jeedom. Bien reconnu par home assistant, il va donc finir en intérieur mais ne tient pas sa promesse en extérieur

Did you find this helpful? Yes 1 No 0

Christian F. published the 31/01/2023 following an order made on 23/01/2023

5/5

conforme à mes attentes

Did you find this helpful? Yes 0 No 0

Victor C. published the 24/07/2022 following an order made on 14/07/2022

5/5

Inclusion simple et rapide. Pas de perte de liaison vérifier après quelques mois (troisième acheté). La pile tiens le coup. c'est comme un Aqara mais en Zwave quoi! Un peu large en dimensions.

Did you find this helpful? Yes 1 No 0

Jean-Louis D. published the 05/07/2022 following an order made on 25/06/2022

3/5

L'ergonomie de ce capteur d'ouverture Zooz est très bonne. Il est discret et facile à fixer. L'insertion avec Jeedom est toutefois laborieuse : le module perd assez facilement sa reconnaissance complète par le réseau z-wave et aussi il faut reprendre le processus d'insertion plusieurs fois. Souvent après qu'une modification intervienne sur le réseau (une absence de réveil du module par exemple suite à une fenêtre laissée ouverte), le module perd son caractère operationnel. Les actions Jeedom ne permettent alors pas, la plupart du temps, de résoudre d'une façon logicielle les blocages de ce capteur Zooz : il faut réintervenir manuellement sur lui soit pour le réveiller (avec 4 appuis) soit pour l'exclure avant de l'inclure à nouveau (avec 3 appuis). Le produit n'offre donc pas avec Jeedom la stabilité requise sur le réseau, et cela, alors que le contrôleur est proche, situé dans la pièce à côté. Fort heureusement les logements avec 40 fenêtres à équiper avec ce capteur sont rares car le client pourrait y passer un moment ; mais pour quelques ouvrants ce capteur Zooz peut convenir. Ce serait donc plutôt un capteur d'appoint. La gestion de la batterie (une pile ronde) paraît incertaine, avec une mesure en pourcentage qui peut diminuer puis curieusement augmenter selon Jeedom (sans remplacement d'une pile neuve sur le capteur) : une fluctuation qui rend cette gestion assez peu fiable et/ou trop tributaire du réveil du module.

Did you find this helpful? Yes 6 No 0

×

You might also like