• Out-of-Stock
EASYFIT - EnOcean Presence Sensor EOSCA
search
  • EASYFIT - EnOcean Presence Sensor EOSCA

EASYFIT - EnOcean Presence Sensor EOSCA



EOSCA

The Ceiling Mounted Occupancy Sensor EOSCA enables a new level of energy saving control for rooms, hallways and other common areas.

This product is no longer available for sale

Saving energy without sacrificing comfort can be effortless with occupancy based controls. The Ceiling Mounted Occupancy Sensor enables a new level of energy saving control for rooms, hallways and other common areas.

The Occupancy sensor uses radio frequency technology to communicate wirelessly with other EnOcean-enabled devices to set back temperature and turn off lights and electrical loads when a space has been unoccupied for a set period of time.

Because the sensors are wireless there is no need to run additional wiring and installation can be completed in a matter of minutes. The sensor is self-powered by harvesting energy from indoor light, eliminating the need for periodic battery changes. The clean, contemporary styling makes it an attractive addition to any décor.

Self-powered wireless occupancy sensors are the perfect energy saving solution for any space where traffic patterns or occupancy determine the need to power the space. Install the occupancy sensors in guest rooms, living spaces, common areas or hallways and link them with a HVAC setback module, thermostat or in-line switch module to ensure that the HVAC, lights and other electronic loads are only on when they are needed.

FEATURES :

  • Communicates wirelessly with other devices using the EnOcean wireless standard.
  • Self-powered. Two integrated solar cells enable indoor light energy harvesting to power the device and eliminate the need for wires or batteries.
  • PIR motion sensor with 360 degree viewing angle lens for maximum efficiency in different room settings.
  • Two molded buttons with LED indicator lights can be used to link and configure the device.
  • Internal tray accommodates supplemental coin cell battery for use in low light environments.

TECHNICAL SPECIFICATIONS :

  • Power Supply: Indoor light energy harvesting Supplemental battery (CR2032) or 2-wire connector for external power or remote solar cell (3 - 5 VDC)
  • RF Communications: EnOcean 868 MHz
  • Transmission Range: 25m
  • Motion Detection Range: 10m diameter (refer to coverage diagrams)
  • Minimum Operating Light: 50 lux (for auto-off only)
  • Startup Charge Times (from empty):
    • First motion transmission / Linking=5 min @ 200 lux
    • Motion LED blink Light/Walk Test Modes=1.5 hours @ 2000 lux
  • Charge Time to Full: 25 hrs @ 200 lux
  • Sustaining Charge Time: 3 hours per 24 hours @ 200 lux
  • Motion Transmission Interval: 2 minutes
  • Unoccupied Transmission: 10 and 30 minutes since last motion detection
  • Heartbeat Transmission: default = disabled / enabled = 1 hr intervals
  • Environment Indoor use: -10° to 40°C, 20% to 95% relative humidity (non-condensing)
  • Operating Life in Darkness: 80 hours (after full charge)
  • Optional Battery Life (Continuous battery-free operation standard):
    • Infrequent Bright Light: 20 yrs (with 200 lux for 2 hrs/day, 7 days/week)
    • Consistent Low Light: 15 yrs (with 65 lux for 5 hrs/day, 7 days/week)
    • Total Darkness: 6.5 yrs
  • EnOcean Equipment Profile (EEP): A5-07-01
  • Dimensions: 160mm x 60mm x 37mm
  • Mounting Height: 2 - 3m recommended
EOSCA

Data sheet

Type
Sensor
Functions
Motion
Technology
EnOcean
Power Supply
Solar cell
Compatibility
Jeedom