

Run your smart home locally, privately, and cloud-free. Z-Stick 7 lets you build your own automation gateway using Gen7 and 700 series Z-Wave technologies.
(à modifier dans le module "Réassurance")
(à modifier dans le module "Réassurance")
The most powerful Z-Wave to USB antenna available, Z-Stick 7 has been engineered atop of Aeotec’s Z-Stick technology and the 700 series Z-Wave / Z-Wave Plus V2 automation stack from Silicon Labs. All new and yet all tried and tested, Aeotec’s inbuilt proprietary technology already powers over 300,000 automation and smart home’s globally. Now a further enhanced version of it bacn power your solution.
Z-Stick 7 is part of Aeotec’s range of turnkey hardware designed to enable solutions makers to build automation solutions without developing custom hardware.
Brimming with new features and technology, yet wholly more compact. Z-Stick 7 is 79% smaller than Z-Stick Gen5+ and yet it is still just as easy to setup.
Your smart home is a secure home with Z-Stick 7. Wireless communication between its Z-Wave antenna and Z-Wave products installed in your home is secured with S2 security's triple-layered security.
Install new devices in seconds. Z-Stick 7 offers SmartStart natively, allowing for new Z-Wave devices to be connected to your system simply by scanning their QR code through a SmartStart-enabled app.
If it isn't locally hosted, your automation system's security and privacy could be at risk. Take control of both by using open-source hardware, such as Raspberry Pi, and software with Z-Stick 7 to host and control your automation setup locally.
If the cloud goes down, so do most automation systems. Z-Stick 7 allows you to bypass cloud control and processing, offering local processing and helping to prevent down-time due to Internet and cloud outages.
Note : Please note that this is a bridge controller - make sure that your software is capable of communicating with it prior to purchase.
FEATURES :
CARACTERISTIQUES TECHNIQUES :
Data sheet
Rémy J. published the 24/11/2022 following an order made on 02/11/2022
Mise à jour du firmware nécessaire, procédure bien détaillée sur le site d'Aeotec. Marche nickel.
Grégory G. published the 16/11/2022 following an order made on 08/11/2022
Dommage que la possibilité d'inclure un device quand la clé n'est pas branchée ait disparu dans cette version. Sinon tout est ok mais je n'ai pas encore inclu beaucoup de modules, donc à voir si ce contrôleur est aussi stable que son prédécesseur.