The FIBARO Motion Sensor remains in a security fault signaling state.

1. The battery is almost discharged.

Replace the battery by opening the housing cover. Then close the case and put it back in place.

2. The FIBARO Motion Sensor is out of range of the Z-Wave controller.

The FIBARO Motion Detector is out of range of the Z-Wave controller. It must be within direct range of the Z-Wave controller or within range of another node on the Z-Wave mesh network.

3. FIBARO Motion Sensor has been reset.

After resetting the FIBARO Motion Sensor, it returns to its default settings. To use it, you must again make the inclusion to your Z-Wave controller.

Related Products

Does this answer your question?
Yes (0)
No (0)
Sorry about that
How can we improve it?
Submit
Thanks
Your feedback helps improve this answer for everyone.