Reset FIBARO Flood Detector
There is only one way to reset the FIBARO Flood Detector. The reset procedure clears the memory of the device, including all Z-Wave network and master controller information. The reset procedure does not remove the Sensor from the Z-Wave network master controller memory. Before resetting a detector, you must remove it from the Z-Wave network.
1. Check that the detector is powered.
2. Hold down the TMP button.
3. Wait 15-20 seconds for the LED to turn yellow to confirm entry into the 4th submenu.
4. Release the button and press once again.
5. Wait a moment until the LED turns red and an acoustic signal confirms the reset.
Related Products
Does this answer your question?
Sorry about that
How can we improve it?
Thanks