How do I exclude my Aeotec TriSensor sensor?
You may need to refer to your controller's device inclusion method if you are unsure how to include a Z-Wave device. You can use any controller to perform an exclusion of the TriSensor even if it is not included to reset the TriSensor to factory settings.
1. Put your Z-Wave controller in exclusion mode, your Z-Wave controller should confirm that it is waiting to delete a device.
2. Press the action button on your TriSensor 3 times within 2 seconds. The TriSensor LED will turn solid purple.
3. If your TriSensor has been successfully kicked out of your network, the LED will flash white, green, white, green twice (white, then green 2 times).
Related Products
Does this answer your question?
Sorry about that
How can we improve it?
Thanks