- Out-of-Stock
EUTONOMY - Adapter DIN for Fibaro Roller Shutter FGR-222 with buttons
EUT_R222
The euFIX R222 Adapter is used to install the Fibaro® Roller Shutter FGR-222 or FGRM-222 module on DIN TH35 type rail in the electrical switchboard.
|
The euFIX R222 Adapter is used to install the Fibaro® Roller Shutter FGR-222 or FGRM-222 module on DIN TH35 type rail in the electrical switchboard.
The euFIX R222 Adapter consists of the case and the base board, where the FGR-222 module is mounted. The dimensions of the case are appropriate for a standard DIN TH35 type rail.
The base board contains a set of screw terminals, where all the wires (power supply, input and output signals, control push- buttons) can be safely connected.
The front panel of the case contains two diagnostics micro-push-buttons S1 & S2, which can be used to control the module, to register the module within the Z-Wave system or to remove it from the system without opening the adapter's case.
FEATURES :
- DIN adapter for Fibaro Roller Shutter FGR-222 or FGRM-222 with push-buttons
- Used to install the Roller Shutter FGR-222 or FGRM-222 module on DIN TH35/TS35 type rail in the electrical switchboard
- Free location on the label to locate the controlled line
- Micro-push-buttons S1 & S2 used for control, inclusion or exclusion of the module within the Z-Wave system
TECHNICAL SPECIFICATIONS :
- Supply voltage: 230 V AC +/-10%, 50–60Hz
- Load power: max 4,5A
- Dimensions: 34.8 x 87.3 x 64.7 mm
- Width in TE units: 2 TE modules
- Conductor wires cross section: max. 2.5 mm2
- Maximum length of wires connected to Sx, S1, S2 inputs: 20m
- Operating temperature: 0 °C to +50 °C
- Relative humidity: ≤90 %, no condensation
- Directives:
- LVD 2014/35/EC
- RoHS 2011/65/EU
EUT_R222
Data sheet
- Type
- Accessory
8 other products in the same category:
Customers who bought this product also bought:
The euFIX R222 Adapter is used to install the Fibaro® Roller Shutter FGR-222 or FGRM-222 module on DIN TH35 type rail in the electrical switchboard.